Beretta A400 Xplor Action Manual download pdf (Page 33)

REASSEMBLY

• Centre the front spacer  on the stock bolt tube. Make sure that the indicator

showing the desired drop and cast (“C-60-DX” in the diagram) is visible on the

spacer.

• Reposition the stock. Place the rear plate  inside the stock. Make sure that

the same marking is visible on the plates.

• Use the 13-mm tube spanner to insert the retaining nut of the stock and spring

washer and tighten down with tightening torque 1.6 - 1.8 Kgm (Kilogram-

meters). The use of a proper dynamometric spanner is recommended.

• (Only for Kick Off versions) Insert the Kick Off recoil absorption device into the

stock and tighten with the special screws using a Torx T15 screwdriver.

• (Only for the Kick Off versions) Mount the Beretta Microcore recoil pad into the

Kick Off holes (Only for the Kick Off versions) or onto the stock. Tighten the

screws using the Phillips screwdriver.

STORAGE

WARNING: To reduce the risk of accidents involving children or unauthorised

persons, keep your ﬁ rearm locked away and store the ammunition in a separate

locked location!

NOTICE: Store the ﬁ rearm disassembled (barrel/fore-end and receiver/stock)

in the supplied case. Before storage, always check the condition of the shotgun

and its case. Ensure that they are perfectly dry.

Moisture and water drops can damage the shotgun.

NOTICE: Do not store the shotgun in a leather or fabric case. These materials

attract moisture, even though they may appear to be perfectly dry.

1 2 ... 28 29 30 31 32 33 34 35

No comments

Beretta A400 Xplor Action Manual Page 33